MappingKit
Holybro X500 V2 PX4 Development Kit (Pixhawk 6X)
Community build by Lystrup Maher (@lystrupmaher)Staff · Published Oct 1, 2026
About this build
This is the entry-level Holybro kit for learning PX4 or ArduPilot. It pairs a 500 mm carbon quad on 10-inch props with a Pixhawk, M10 GPS and SiK telemetry. It costs much less than the X650 and carries a lighter payload, so it works well as a first mapping or autonomy starter platform. There are no DJI parts.
Buy this kit
Parts list from holybro.com
Parts list
0 of 10 parts are in our catalog
| Frame | Holybro X500 V2 frame kit (500mm, 16mm CF tube arms, CF landing gear) | Not in our catalog |
| Flight controller | Holybro Pixhawk 6X | Not in our catalog |
| ESC | Holybro BLHeli S 20A ESC (single ESC, XT30) × 4 | Not in our catalog |
| Motors | Holybro 2216 (920KV) × 4 | Not in our catalog |
| Propellers | Holybro 1045 propeller (10x4.5) × 4 | Not in our catalog |
| GPS | Holybro M10 GPS | Not in our catalog |
| Other parts | Holybro SiK Telemetry Radio V3 (915MHz) | Not in our catalog |
| Other parts | Holybro PM02D power module | Not in our catalog |
| Receiver | RadioMaster RP3 V2 ELRS 2.4GHz | Not in our catalog |
| Battery | 4S LiPo 20C+, XT60 (3000-5000mAh) | Not in our catalog |