MappingKit
Holybro X650 Development Kit (Pixhawk 6X)
Community build by Lystrup Maher (@lystrupmaher)Staff · Published Oct 1, 2026
About this build
A large PX4/ArduPilot development quad with 15.5-inch props, pre-installed propulsion and a full Pixhawk autopilot, GPS and telemetry radio. It suits survey, mapping and payload experiments where you want open-source autopilot firmware and around half an hour of hover time. Nothing on it comes from DJI.
Buy this kit
Parts list from holybro.com, pyrodrone.com
Parts list
0 of 10 parts are in our catalog
| Frame | Holybro X650 V2 frame (carbon fiber, foldable arms, 15.5in props) | Not in our catalog |
| Flight controller | Holybro Pixhawk 6X | Not in our catalog |
| ESC | Holybro Tekko32 F4 45A ESC (single ESC, XT30) × 4 | Not in our catalog |
| Motors | T-Motor MN4014 (330KV) × 4 | Not in our catalog |
| Propellers | Gemfan 1555 carbon fiber (15.5x5.5) × 4 | Not in our catalog |
| GPS | Holybro M10 GPS | Not in our catalog |
| Other parts | Holybro SiK Telemetry Radio V3 (915MHz) | Not in our catalog |
| Other parts | Holybro PM02D power module | Not in our catalog |
| Receiver | RadioMaster RP3 V2 ELRS 2.4GHz | Not in our catalog |
| Battery | 6S LiPo/Li-ion, XT60 (5000-12000mAh) | Not in our catalog |